The green links below add additional plants to the comparison table. Blue links lead to other Web sites.
enable glossary links

bladder-fern, brittle fern, fragile fern

cystoptère des montagnes, mountain bladder fern, mountain brittle fern

Habit Plants terrestrial or on rock.
Stems

short- to long-creeping, stolons absent.

long-creeping, cordlike, internodes 1–2(–4) cm, old petiole bases few, hairs absent;

scales usually tan to light brown, ovate-lanceolate, radial walls tan to brown, thin, luminae tan.

Leaves

monomorphic, dying back in winter.

monomorphic, at stem apex but not tightly clustered, to 45 cm, sori production about equal on all leaves (fairly independent of season).

Petiole

1/3–3 times length of blades, base often swollen and persisting as trophopod over winter;

vascular bundles 2, lateral, round or oblong in cross section.

dark brown to black at base, gradually becoming green or straw-colored distally, (1–)2–3 times length of blades, sparsely scaly throughout.

Blade

ovate-lanceolate to deltate, 1–3-pinnate-pinnatifid, gradually reduced distally to a pinnatifid apex, membranaceous to herbaceous.

elongate-pentagonal, 3(–4)-pinnate-pinnatifid;

rachis and costae lacking gland-tipped hairs or bulblets;

axils of pinnae with occasional multicellular gland-tipped hairs.

Pinnae

not articulate to rachis, segment margins crenulate, dentate, or serrate;

proximal pinnae not reduced or 1 pair slightly reduced, sessile or petiolulate, equilateral or ± inequilateral, if inequilateral basiscopic side more narrowly cuneate;

costae adaxially grooved, grooves continuous from rachis to costae;

indument absent or of uniseriate, multicellular hairs in pinnae axils or of unicellular, gland-tipped hairs abaxially, absent adaxially.

ascending, typically at acute angle to rachis, only proximal pinnae occasionally curving toward blade apex, margins serrate;

proximal pinnae pinnate-pinnatifid, inequilateral, basal basiscopic pinnule stalked, enlarged, base truncate to obtuse;

distal pinnae deltate to ovate.

Veins

free, simple or forked.

directed into notches.

Indusia

cup-shaped, apex truncate, hairs gland-tipped only along margin.

Sori

in 1 row between midrib and margin on ultimate segments, round;

indusia ovate to lanceolate, hoodlike and arching over sorus toward margin, attached to receptacle base on costal side, persistent to ephemeral or often obscure at maturity.

Spores

brownish, echinate, or verrucate.

spiny, usually 37–42 µm. 2n = 168.

x

= 42.

Cystopteris

Cystopteris montana

Phenology Sporulating summer–fall.
Habitat Terrestrial in wet woods or along water courses
Elevation rare; 0–3500 m (rare; 0–11500 ft)
Distribution
from USDA
Worldwide
[BONAP county map]
from FNA
AK; CO; MT; AB; BC; NB; NF; NS; NT; ON; QC; SK; YT; Greenland; Eurasia
[WildflowerSearch map]
[BONAP county map]
Discussion

Cystopteris is a taxonomically difficult genus at the species level. Especially troublesome is the worldwide and polymorphic species C. fragilis sensu lato. To maintain it as a single species with several varieties would be easiest (and least controversial). This approach, however, may not accurately reflect true evolutionary history.

Although Cystopteris species are found in temperate climates worldwide at tetraploid to octaploid ploidy levels, extant diploid species are concentrated in North America. The diploid species are relatively distinct from one another and are the progenitors of numerous allopolyploid derivatives (see reticulogram). In addition, an extinct (or undiscovered) diploid may have been involved in the origin of some polyploids (shown as "C. hemifragilis" on the reticulogram).

Considerable overlap exists among the leaf morphologies in the species of Cystopteris, even among the diploid taxa. Consequently, the key requires observation of subtle and sometimes overlapping characteristics.

Several general recommendations can be made for identifying Cystopteris. (1) Field workers should be aware that whenever Cystopteris species occur together, hybridization is likely; hybrids usually have shriveled and malformed spores. (2) Species of Cystopteris frequently occur as highly reduced plants, especially in stressful habitats such as high elevations, high latitudes, and cold and/or dry climates. Such stunted plants can be fertile, but leaf and stem characters required to distinguish species can be obscured. (3) Because of the importance of examining stem and spore features in distinguishing species, collectors should always attempt to obtain complete, fertile specimens.

Species ca. 20 (9 in the flora).

(Discussion copyrighted by Flora of North America; reprinted with permission.)

Cystopteris montana, the most distinctive of the Cystopteris in the flora, probably is allied to Asian species. Although this boreal species is restricted primarily to high latitudes, it occurs disjunctly at high elevations in Colorado, where its habitats are being threatened by development. Cystopteris montana does not hybridize with any other Cystopteris in the flora, but it has been implicated in the origin of the European allopolyploid C. alpina (Roth) Desvaux.

(Discussion copyrighted by Flora of North America; reprinted with permission.)

Key
1. Leaf blades elongate-pentagonal; proximal pinnae inequilateral, with enlarged basiscopic pinnules; stems cordlike, long-creeping, leaf bases more than 1 cm apart.
C. montana
1. Leaf blades elliptic to deltate; proximal pinnae equilateral or nearly so; stems not cordlike, short-creeping (leaf bases less than 0.5 cm apart) or if long-creeping, leaf bases generally less than 1 cm apart.
→ 2
2. Rachises, costae, indusia, and midribs of ultimate segments sparsely to densely covered by gland-tipped hairs; leaf blades deltate to ovate, usually widest at or near base; rachises and costae often with bulblets.
→ 3
2. Rachises, costae, indusia, and midribs of ultimate segments without glandular hairs; leaf blades elliptic to lanceolate, generally widest at or just below middle of blade; rachises and costae without bulblets.
→ 6
3. Rachises and costae frequently with bulblets; rachises, costae, indusia, and midribs of ultimate segments usually densely covered by gland-tipped hairs; leaf blades broadly to narrowly deltate, almost always widest at base, apex long-attenuate; leaves seasonally bearing sori (earliest leaves lack sori, subsequent leaves with sori); petioles reddish when young, green or straw-colored in mature specimens; spores usually 33-38 µm.
C. bulbifera
3. Rachises and costae occasionally with bulblets (often misshapen); rachises, costae, indusia, and midribs of ultimate segments usually sparsely covered by glandular hairs; leaf blades narrowly deltate to ovate-lanceolate, widest at or near base, apex short-attenuate; nearly all leaves bearing sori; petioles dark brown to straw-colored or green; spores usually 38-60 µm.
→ 4
4. Blades ovate to lanceolate, usually widest above base; spores usually 49-60 µm; ne North America.
C. laurentiana
4. Blades deltate to narrowly deltate, usually widest at or near base; spores usually 38-48 µm; e,c to sw North America.
→ 5
5. Stem scales usually dark brown, ± clathrate, cell walls dark brown, thick, luminae prominent; leaves usually with multicellular, gland-tipped hairs in axils of pinnae; sw United States.
C. utahensis
5. Stem scales usually tan to light brown, cell walls brown, thin, luminae not obvious; leaves rarely with multicellular, gland-tipped hairs in axils of pinnae; e United States (e Kansas, s Minnesota throughout East Coast area).
C. tennesseensis
6. Leaves clustered 1-4 cm behind protruding stem apex; stems pubescent, hairs yellow; spores usually 28-34 µm.
C. protrusa
6. Leaves clustered at stem apex; stems lacking hairs; spores usually 33-60 µm.
→ 7
7. Proximal pinnae pinnate-pinnatifid to 2-pinnate; stems usually long-creeping; spores usually 33-41 µm.
C. reevesiana
7. Proximal pinnae pinnatifid to pinnate-pinnatifid; stems short-creeping; spores usually 39-60 µm.
→ 8
8. Pinnae typically at acute angle to rachis, often curving toward blade apex; pinnae along distal 1/3 of blades ovate to narrowly elliptic; margins of pinnae usually crenulate or with rounded teeth; basal basiscopic pinnules of proximal pinnae cuneate to rounded at base.
C. tenuis
8. Pinnae typically perpendicular to rachis, not curving toward blade apex; pinnae along distal 1/3 of blade deltate to ovate; margins of pinnae with sharp teeth; basal basiscopic pinnules of proximal pinnae truncate to rounded at base.
C. fragilis
Source FNA vol. 2. Authors: Christopher H. Haufler, Robbin C. Moran, Michael D. Windham. FNA vol. 2.
Parent taxa Dryopteridaceae Dryopteridaceae > Cystopteris
Sibling taxa
C. bulbifera, C. fragilis, C. laurentiana, C. protrusa, C. reevesiana, C. tennesseensis, C. tenuis, C. utahensis
Subordinate taxa
C. bulbifera, C. fragilis, C. laurentiana, C. montana, C. protrusa, C. reevesiana, C. tennesseensis, C. tenuis, C. utahensis
Synonyms Polypodium montanum
Name authority Bernhardi: Neues J. Bot. 1(2): 26. (1805) (Lamarck) Bernhardi ex Desvaux: Mém. Soc. Linn. Paris 6(2,3): 264.1827
Web links